- Pre-assembled on acrylic board for easy out of box test run
- Control CNC over USB instead of via Parallel Port
- Arduino UNO R3 Board (Preloaded with g-code library)
- Limit Switch with Wiring Harness
- Arduino Shield with Wiring Harness
- 1 X Arduino UNO R3 Board (Preloaded with g-code library)
- 1 X Arduino Shield
- 3 X Single Axis 2.5A Stepper Motor Driver
- 6 X Limit Switch & Wiring Harness
- 1 X Mean Well 12V 5A Power Supply (110/220V)
- 1 X Mushroom Emergency Stop Switch
- This package includes electronic components that will allow to control up to 3 axis stepper motors.
- You CANNOT use this Arduino control package with Mach3 software.
- The benefit of this Package is the ability to control CNC over USB instead of via Parallel Port.
- Arduino based electronics kit also uses FREE open source software as its control interface.